These rather dirty but beautiful classic Minster Limestone flagstones had been installed in the Kitchen of a house in the village of Austwick. They were now overdue for a deep clean and polish and so we were asked to do to the work.
Stripping and Polishing Limestone Floor Tiles
To restore the surface of polished stone we use a set of diamond encrusted pads however before starting we gave the floor tiles a general clean with a dilution of Tile Doctor Pro-Clean mainly to clean-up the grout and secondly to remove any loose surface grit. This was rinsed away and removed with a wet vacuum before starting the burnishing process using a rotary scrubbing machine fitted with a coarse diamond encrusted burnishing pad and a little water. The coarse pad strips off dirt and old sealers from the tile and the resulting slurry is then removed using a wet vacuum.
The burnishing pads come in a set of four so once we were done with the coarse pad we moved on to the Medium and then Fine pads again with a little water until the floor was polished. To bring up the polish on the Limestone tiles the last “Very Fine” pad was fitted to the rotary machine and run over the floor to buff it to a nice shine.
Sealing Limestone Floor Tiles
Once the floor was dry we set about sealing it using two coats of Tile Doctor Ultra Seal which is a penetrating sealer that soaks into the pores of the stone filling them so dirt can’t penetrate below the surface. As well as offering excellent protection Ultra Seal doesn’t enhance the stone the stone in anyway giving it a natural look. Once sealing was complete and dry the Limestone tiles were given a final buff with a soft white pad.
I think you will agree that the Limestone tiles now look much better and now that’s it’s been sealed cleaning the floor should be so much easier.